Raising the Antenna
1. Press and hold “POWER” for two seconds to turn on the interface
box. Wait until the interface box finishes “connecting to antenna.” The
TRAV’LER
®
antenna may enter the search routine after ten seconds.
Pay attention to the pinch points as the antenna raises!
2. Wait until the antenna has at least raised to a position in which the
feed arm is parallel to the roof. Then, press “POWER” and “SELECT”
at the same time. The antenna should stop moving.
3. Unplug the interface box. Continue with instructions for your model of
replacement sheathed cables.
Model RP-SK41 DISH
®
Pro Plus 1000
&
Bell TV
Replacement Cables
1. Remove and set aside the two screws
from the wider end of the underside
of the integrated adapter.
2. Carefully slide the LNB out from the
integrated adapter. Disconnect the
three cables from the LNB using a
7
/
16
” wrench.
3. Using a
7
/
16
” wrench, disconnect
the three cables from the coax ports
on the top of the turret.
4. Using a
5
/
16
″
wrench, remove the screw holding the p-clamp to the
lift arm, and detach the p-clamp from the lift arm. Set the screw and
p-clamp aside; you will need these later.
5. Once disconnected, remove the sheathed cables.
6. Run the replacement sheathed cables through the feed arm.
7. Connect the three cables closest to the the integrated adapter to ports
1–3 (in any order) on the LNB. Tighten each cable until fingertight, and
then use a
7
/
16
” wrench to tighten a quarter turn more.
8. Slide the LNB into the integrated adapter, and re-install the two
screws (removed earlier) through the integrated adapter and LNB.
1
Screws removed
from integrated adapter
LNB slid out from
integrated adapter
Integrated
adapter
