RAISING THE ANTENNA
1. Press and hold “POWER” for two seconds to turn on the interface box. Wait until
the interface box finishes “connecting to antenna.” The TRAV’LER
®
antenna may
enter the search routine after ten seconds.
Pay attention to the pinch points as the antenna raises!
2. Wait until the antenna has at least raised to a position in which the feed arm is
parallel to the roof. Then, press “POWER” and “SELECT” at the same time. The
antenna should stop moving.
3. Unplug the interface box. Continue with instructions for your model of
replacement LNB.
RP-SK01 DISH
®
1000 / RPSK01H HYBRID
LNB REPLACEMENT
1. Remove and set aside the two screws
from the wider end of the underside of
the integrated adapter.
2. Carefully slide the LNB out from
the integrated adapter. Disconnect
the three cables from the LNB using
a
7
/
16
” wrench.
3.
RP-SK01-
Connect the three cables
running through the integrated adapter
to ports 1–3 (in any order) on the
replacement LNB. Tighten each cable until fingertight, and then use a
7
/
16
”
wrench to tighten a quarter turn more.
RPSK01H –
Using the supplied dual coax cable, connect the ends with red heat
shrink wrapping to Port 1 on LNB and Port C on TRAV’LER turret. Connect the
black coax cables to Port 2 on LNB and Port A on TRAV’LER turret.
THE HOPPER 3 AND ALL COMPONENTS MUST CONNECT TO PORT C
ON TRAV’LER BASE. PORT A AND B WILL NOT BE USED FOR REGULAR
CONFIGURATIONS.
Tighten each cable until fingertight, and then use a
7
/
16
” wrench to tighten a
quarter turn more.
4. Slide the LNB into the integrated adapter, and re-install the two screws (removed
earlier) through the integrated adapter and LNB.
Screws removed
from integrated adapter
LNB slid out from
integrated adapter
Integrated
adapter
