8
Retaining nut
Power coupler
Power/control
cable
Exterior nut
Power/control
cable
Retaining nut
Base
Screws (9)
FIGURE 14.
Remove turret from transition plate
Transition plate
Transition plate
Disconnect the Cables
1. Remove the four 5/16" screws from the cable cover, and
remove the cable cover (figure 11).
2. Unclip the power coupler from the internal power cable.
Unthread and remove the power/control cable retraining nut
located inside the turret. See figures 12 and 13.
Remove the Reflector
(optional)
Once the IDU has been powered off and the power/control
cable and power cord have been disconnected you will need
to get on top of the coach. The tools needed are a 7/16" wrench
or socket.
1. To remove the reflector remove the four 7/16" nuts from the
back of the reflector using a 7/16" wrench or socket.
Remove the Turret
1. Remove the nine 5/16" screws around the edge of the
transition plate, see figure 14.
Screws (4)
NOTE
You may need to use the adjustable
wrench to loosen the retaining nut.
WARNING
Be careful not to lose the
retaining nut inside the turret.
FIGURE 13.
Power coupler unclipped
FIGURE 12.
Unclip the power coupler
FIGURE 11.
Remove the four screws on the cover
