(2) E-Clip
WARNING:
INSTALLATION OF ANTENNAS NEAR POWER LINES IS DANGEROUS.
FOR YOUR SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS.
INSTALLATION
This SENSAR antenna may be installed inside or outside on any mast or
pole.
DO NOT MOUNT OVER CHIMNEY OPENING.
STEP 1.
Make sure "W" opening is on bottom side of antenna head. Slide
metal mounting bracket up into back bracket on antenna and attach with
pins and E-clips. See Figure 1.
STEP 2.
Insert "U" bolt thru mast clamp and mast bracket and start hex
nuts onto "U" bolt. See Figure 1.
STEP 3.
Slide mast thru "U" bolt and tighten hex nuts with 7/16" wrench.
See Figure 4.
Model GS-1000, VM-1000 (Non-amplified Models ONLY)
Attaching Downlead Cable
STEP 1.
Attach downlead cable to F-jack on back of antenna head, tighten
securely and slide weather boot onto the boot collar. Tape downlead to
mast and run cable to TV.
STEP 2.
Attach "F" connector to downlead and connect to "F" jack on TV.
(2) Pin
(2) Hex Nut
Mast Bracket
U-Bolt
Mast Clamp
Figure 1
Figure 4
Model GS2000A
(Amplified Models ONLY)
Attaching Downlead Cable
STEP 1.
Attach downlead cable to F-
jack on back of antenna head, tighten
securely and slide weather boot onto
the boot collar. Tape downlead to mast
and run cable to power supply location.
STEP 2.
Attach "F" connector to
downlead and connect to "F" jack on
power supply marked "TO PREAMP".
See Figure 2.
STEP 3.
Attach "F" connector to cable
from TV and connect to "F" jack on
power supply marked "TO TV". See
Figure 2.
STEP 4.
Mount the two #6 screws
vertically 3-1/4" apart leaving screw
heads approximately 1/8" from wall.
See Figure 3.
STEP 5.
Hang power supply onto
screws and plug power supply AC
power cord into receptacle.
Figure 2
U.S. Pat. No. D355,887,
D358,365, 5,515,240 Power
supply housing design.
Figure 3
3-1/4"
#6x1/2
Screws
CAUTION: No splitters or coupler should be installed in the coax
line between the antenna and power supply.
Attach
coax here.
NOTICE: FAILURE TO PROPERLELY CONNECT
CABLES MAY RESULT IN DAMGE TO TV SET.
TO PREAMP
TO TV
