Winegard Sensar HV CC-10HV, Installation & Operation Manual

Page: 6 / 16

4
the directional handle with the
keyways on the bottom of the
gear housing. (The keys only line
up one
way—do
not force.)
Carefully align the keys inside
Pull the handle down, and transfer
7
this dimension to the shaft end of
the directional handle. Mark this,
and cut the handle at the mark.
Push the directional handle up
into ceiling and over the shaft.
Measure the distance between
the bottom of the recess on the
handle to the ceiling.
Determine the roof thickness. The mount is designed to fit roofs from 2.5 cm to 12 cm thick.
•
If the roof is less than or equal to 12 cm thick, continue to step 2.
•
If the roof is more than 12 cm thick (max. 17.8 cm), a directional handle extension is needed.
Winegard recommends model EK-1036 directional handle extension (sold separately).
Lay the ceiling plate on top of
the directional handle with
the pointers aligned.
2
Slide the ceiling plate and
directional handle assembly over
the rotating base shaft.
Make pilot holes in the ceiling.
Then, mount the ceiling plate with
the four provided screws.
3
The knobs on the
directional handle
should fit into the grooves
on the ceiling plate.
3
6
The pointer on the handle should point
toward the back of the coach.
The handle cut
must be flat.
Thick key
below ceiling
Cut shaft here
Cut handle here
Cutting the Directional Handle to fit Roof Thickness
1
Sold Separately
2
Inside the vehicle, mark the
elevating shaft 3.8 cm below the
ceiling. Cut the shaft on this mark.
3.8 cm
Directional
handle
5 Make sure the top of the
directional handle is snug against
the bottom of the base plate.
distance x
distance x
TIP
Installing the Crank Assembly
1
Pointers
TIP
5 Winegard Sensar HV Antenna
EK-1036
Thin key