Select
Test
.
It will go through a number of
steps, then return to the screen
shown here with previous
information cleared.
If at any point it asks you to save,
select
Save
or
Yes
.
Reconnect the coaxial cable to the “Sat In” port
on back of receiver. Now
turn on
the antenna
. Allow it 3–4 minutes to acquire satellites.
(
If you have an In-Motion system,
after the search routine is complete the system
will take another 6 minutes before going into “Sleep Mode”. Once it does, the unit
will be completely silent.
Do not proceed to Step 6 until this has happened.
)
Select option 1,
Point Dish
.
Before turning the Mission antenna on, follow the steps below
to clear out any existing receiver settings. If your receiver differs
from the options shown, you may need to consult your receiver
manual. The wording and display used in your receiver may
differ slightly.
For help, email [email protected] or call 1-800-788-4417
Before starting, disconnect coax
cable from “Sat In” on back of
receiver. Press
Menu
on your
remote. Select option 6,
System
Setup
.
Select option 1,
Installation
.
Move over to select
Check
Switch
.
Check that there are no
checkmarks by SuperDISH or
Alternate.
Next, select
Test
again.
This time it will install the
SW64 switch.
This SW64 switch
is a DISH receiver setting, not a
physical part.
When you see the SW64 as the
installed switch, the antenna is ready for use.
DISH Receiver Setup
1
Mission Antenna 8
2
7 Mission Antenna
Disclaimer: Receiver setup instructions are accurate at time of printing and may change without
notice. Call Winegard tech line for assistance: 1-800-788-4417.
3
4
5
6
DISH Receiver Setup
