3 RoadStar Antenna
3
4
5
6
7
Mounting Option 1
RoadStar Antenna 4
Mounting Option 1
1
2
8
9
10
11
Drill a 5/8” hole in the roof at the
chosen location for the antenna.
Make sure the ceiling area is
clear underneath the chosen
location for the antenna.
Run the coax cable from the
power supply upward through
the circular gasket and pedestal.
Place the gasket and pedestal
in the chosen location for the
antenna, and trace around the
edge of the gasket.
Plug the slot in the pedestal with
the provided rectangular gasket.
Run coax cable from the chosen
location for the power supply
through the ceiling and through
the hole drilled for the antenna.
Connect the
coax cable
running from
the power
supply to the
coax cable
running from
the antenna
head.
Before using the supplied
screws, check with your vehicle
manufacturer for any screw
requirements. Then, align the
holes in the gasket and pedestal,
and mount the assembly to
the roof with
four screws.
Gently push the cable through
the pedestal until the connector is
below the notch in the pedestal.
Check with your vehicle
manufacturer for approved
sealant for your vehicle. Then,
apply a liberal amount of sealant
to the traced circle on the roof.
Replace the pedestal and gasket.
Run a solid bead of sealant
where the edge of the pedestal
meets the roof and over the
screw heads.
Slowly rotate the antenna head while gently pushing down on the
antenna head. Once the keys on the pedestal align with the grooves in
the antenna head, you should hear the head “click” into place. (
You may not
be able to see the keys and grooves align, but the head will not fully snap into place until
these parts align.
) The head and pedestal should be connected. Continue
with installing the power supply on page 7.
Pedestal
Rectangular
gasket
Slot
S
ea
l h
er
e
w
her
e
p
e
d
e
st
al m
e
et
s
ro
o
f
.
Circular gasket
Pedestal
Groove
Key
Ap
ply sealant her
e
Connector
Notch
