10.
3
receiver setup instructions are accurate at time of printing and may change without notice.
1.
2.
5.
3.
4.
5.
6.
7.
8.
9.
11.
12.
13.
receiver setup
Connect the receiver to a power source, and complete
receiver setup. receiver setup for the primary receiver
follows; if your receiver differs from the options shown, you
may need to consult your receiver manual. the wording and
display used in your receiver may differ slightly.
DIreCtV receiver setup
Press
Menu
on your remote.
select
Parental, Fav’s & Setup
.
select
System Setup
.
In your receiver menu, you will need to identify the satellite
menu. once there, find the option for
Satellite Setup
.
You may be required to press the
DASH (-)
before proceeding
(underneath #7 on the remote).
select
3-LNB (18”x 20”)
or
3 Satellites
. If given the option of
swM or Multiswitch, select
Multiswitch
.
Power on the antenna, and allow the antenna a few minutes
to acquire signal. once the antenna has finished acquiring
signal, the antenna will be silent.
After the antenna has acquired signal, press
Continue
; the
receiver will automatically verify the setup.
errors may be displayed on the screen. It is normal to see one
or two boxes with an
X
instead of a
.
select
Continue
.
select
Continue
again. the program guide will download.
when the status bar reaches 100%, press
Continue
.
the receiver will run Data Feed and Guide Feed tests for a
few moments.
when prompted to set up the remote, select
Setup Remote
Later
to do this at a later time.
select
Watch DIRECTV
. receiver setup is now complete.
Carryout G2
+
Antenna