5
Vinobox
,C
50 2T
The controls of your wine Cooler
•
RUN
Indicator light illuminates to signify the cooling mode is currently in operation.
•
Light
To control the inner light turn on/off.
•
Power
To control this
appliance turn on/off.
•
“Set Upper” Button
To set the temperature of the upper chamber.
•
“Set Lower” Button
To set the temperature of the lower chamber.
•
“Up chamber”
To shows the temperature of the up chamber.
•
“Lower chamber”
To shows the temperature of the lower chamber.
Setting the Temperature Control
•
Each cooling compartment of the wine cooler (upper & lower) is independently
controlled. To set the temperature:
Connect the power cord to a properly grounded outlet. In the event of a power interruption,
all previous temperature settings are automatically erased and each compartment will
default to a preset temperature setting of: 6 for upper compartment and 12 for lower
compartment.
•
Set the desired cooling temperature by pressing the buttons adjacent to the “set
upper/set lower” program. Each depression of the buttons will scroll through the
available temperature settings (for each compartment) in increments of 1 degree. The
temperature selected will flash in the LED display for approximately 5 seconds, then
revert back to display the temperature of the internal cabinet
Upper compartment
: The temperature setting can be adjusted from 5 to 10 .
Lower compartment:
The temperature setting can be adjusted from 10 to 18 .
•
To view the “set” temperature. (anytime) press and hold the corresponding button for
approximately 5 seconds, the “set” temperature will temporarily “flash” in the LED display
for 5 seconds.
Note
•
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the Wine Cooler will
not start.
•
When you use the wine cooler for the first time or restart the wine cooler after having
been shut off for a long time, there could be a few degrees variance between the
temperature you select and the one indicated on the LED readout. This is normal and it
is due to the length of the activation time. Once the wine cooler is running for a few
hours everything will be back to normal.
