Figure 5
Figure 6
6. At this point the rack should look like the photo shown above. (Fig. 5)
7. Locate the rear panel and place an elevator bolt through the side face of the front panel just below the third horizontal wire from the top. (Fig. 6)
8. Attach all four elevator bolts in the same manner as the front panel.
Figure 7
Figure 8
9. After all of the bolts have been inserted and loosely covered with the dome nuts, level the rack on the floor. Once the rack has been leveled, tighten
all of the dome nuts.
10. The rack should look like the photo above. (Fig. 7)
