z
Before connecting the appliance to the power source, let it stand upright for
approximately 4 hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
z
Clean the interior surface with lukewarm water using a soft cloth and leave doors open to air out
BEFORE
plugging in your appliance
.
¾
Installation of Your Appliance
z
This appliance was designed to be free standing only, and should not be recessed or built-in.
z
Please note that you should leave at least
8" space
from back wall.
z
Please note that you should leave at least
6" space
for each side.
z
Place your appliance on a floor that is strong enough to support it even when it is fully loaded.
Floor surface should be even.
z
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.)
Direct sunlight may affect the coating and heat sources may increase electrical consumption.
Extreme cold ambient temperatures may also prohibit the unit from performing properly.
z
Avoid locating the unit in moist areas.
z
Never put heavy articles on top of the unit.
z
Plug the appliance into an exclusive, properly installed-grounded 110 volt wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified electrician
or a service center authorized by The Wine Enthusiast.
¾
Electrical Connection
a
WARNING
a
Improper use of the grounded plug can result in the risk of electrical shock. If the power
cord is damaged, have it replaced by a service centre authorized by The Wine Enthusiast.
z
This appliance requires a standard
110 Volts A.C. ~/ 60Hz
electrical outlet with three-prong
ground.
z
This appliance should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three prong wall outlets to
minimize the possibility of electrical shock.
z
Plug the appliance into an exclusive properly installed-grounded 110 volt wall outlet.
Do not
under any circumstances cut or remove the third (ground) prong from
the power cord
.
Any questions concerning power and/or grounding should be directed to a certified electrician
or a service centre authorized by The Wine Enthusiast.
z
The cord should be secured behind the appliance and not left exposed or dangling to prevent
accidental injury.
z
Do not use an adapter plug with this appliance.
z
Do not use an extension cord with this appliance. If the power cord is too short, a qualified
electrician or service technician is needed to install an outlet near the appliance.
¾
Setting the Temperature Control by Mechanical Control Knob
To control the internal temperature, adjust the control dial to achieve
your desired temperature.
Temperature can be adjusted from
Max
Temp (Big Snowflake) /
Mid
Temp /
Min
Temp (Small Snowflake). See page 2 for model
temperature range.
For glass door units, the temperature control is approximately
50-65F
.
To turn off the appliance, turn both temperature controls to minimum
setting (small snowflake) and unplug the appliance
Turning the temperature control to the “
minimum
” position can stop
the cooling cycle of the corresponding chamber, but does not cut off the
power to the appliance.
Mechanical
Control
Knob
It is recommended that you to install the appliance in a place where the
ambient temperature is between
72-78 degrees
Fahrenheit. If the
ambient temperature is above or below the recommended temperatures,
the performance of the unit may be affected. For example, placing your
unit in an extreme cold or hot condition may cause interior temperatures
top fluctuate. The range of degrees Fahrenheit (also subject to door-see
above) may not be reached.
CARE AND MAINTENANCE
¾
Cleaning Your Appliance
z
Turn both temperature controls to minimum, unplug the appliance, and remove all items
including the shelves.
4
5
