Filter level indicator
If warning light (18) comes on check:
a) Is the dust bag full ?
b) Is there a blockage in the hose or power
head ?
Brush controller
The electronic brush controller monitors the
operation of the brush.
Green light:
Brush correctly set and running.
Green light and red light:
Adjust the brush
setting by turning the Pile adjustment knob
(19) to a lower number.
If the lights still show at position number one
the brush strip is worn out and must be
replaced.
Red light:
The brush has become blocked
and is not turning. Switch off. Unplug from
the outlet and clear the blockage.
Maintenance
CAUTION - Always unplug machi-
ne at mains outlet before dis-
mantling any part of the machine.
For guarantee use only genuine
Windsor-Parts (e.g. Filter Bags,
Filtres, Brush strip, etc.)
Changing the paper bag
To change the dust bag: Remove back cover.
Push down lever (20). Lower dust bag from
connecting tube. Close aperture of dust bag
top with cardboard cover (21 A). To fit new
dust bag: Insert top of dust bag (21) into slot
(22). Push lever (20) down and fit
aperture of dust bag top over connecting
tube. Return lever so that it is in horizontal
positon.
Changing filters
Vacuum motor filters (23) - Replace after ca.
20 paper bags have been used.
Exhaust filter (24) - Change when it becomes
dirty.
Press the button (25) and pull the filter for-
wards. To insert a new filter, locate the filter
into the motor housing and push up until the
button (25) engages into place.
Clearing blockages
If the bag-full warning light shows before the
dust bag is full check for blockages. Release
the hose by squeezing the tabs of the
retaining ring (11). Reverse the hose and put
the wand-end into the connecting tube (12).
Remove the obstruction by switching on the
machine, holding the hose upright. If
necessary rapidly lift your hand on and off
the end of the hose. Never use a stick to
clear the hose.
Changing the brush strip
To replace brush strip: Remove brush strip
cover (26). Turn brush roller so that the brush
strip can then be pulled out. Ensure that the
new brush strip is fully inserted.
N.B. Replace the brush strip before the brist-
les wear down to the level of the support rod.
Summary of Contents for VERSAMATIC VS14
Page 1: ...VS 14 VS 18...
