28
Maintenance
4. Scrub Brushes
There are four different types of brushes available to
cover applications from cleaning heavily soiled floors to
polishing. A pad driver is also available to take
advantage of the many cleaning pads on the
market.Please refer to the following to assist in
selecting the proper brush or pad for the work at hand.
Uncoated Floors
Aggressive Grit
is a nylon fiber impregnated with
silicone carbide grit. It grinds away stain, soil, and
removes surface material.
Mild Grit
is a less aggressive silicone carbide grit
suitable for cleaning medium soil conditions.Advan-
tages are faster ground speed than nylon bristles on
light solid applications.
Polypropylene
is a general-purpose scrub brush with
stiff bristles. Polypropylene works well for maintaining
concrete, wood and tile floors.
Finished Floors
Nylon
bristles are used in a variety of applications on
coated or uncoated surfaces.
White Pads
(Polishing) are used for dry polishing to
achieve a high-gloss appearance, or surface washing
on highly polished or burnished floors.
Red Pads
(Buffing) are used for light-duty scrub-
bing.When used with a mild detergent they will provide
surface cleaning without removing the finish.
Blue Pads
(Scrubbing) are used for heavy-duty
scrubbing and light stripping. The blue pads remove
less finish than brown stripping pads, yet will remove
black marks, stains and dirt.
Black Pads
(Stripping) are used for easy and complete
removal of old floor waxes/finishes. They will quickly
remove ground in dirt, black heel marks, and
spills.When used with the proper stripper, this pad
leaves the floor clean and ready for finishing.
The scrub brushes should be checked before each
days work for wire, string, wear and damage.
Replacing Or Installing Scrub Brushes
1.
With the scrub deck up, turn “OFF” the machine.
FOR SAFETY: Before leaving or servicing the
machine; stop on level surface, turn OFF machine
and remove key.
2.
Remove the brush cover shrouds.
3.
Locate release lever on top of brush or pad
driver.Rotate release lever counter-clockwise and
the brush/pad driver will release and drop down.
4.
To reinstall, center the brush driver under the brush
drive hub. Raise until it contacts brush driver
assembly. Turn clockwise until release lever plate
locks into position.
5.
Replace the brush cover shrouds.
NOTE: Check that release plate is completely closed
and pad/brush is securely attached. Damage to driver
or brush could occur.
5. Recovery Tank Float Shut-off
When water is no longer being vacuumed from the
floor and the vacuum fan is operating, the ball float
has engaged. The vacuum motor will not vacuum
water with recovery tank full. The recovery tank
must be drained.
1.
The float shut-off screen can be cleaned in or out
of the machine.
2.
To clean the float shut-off while it is inside the
machine wipe material off screen then rinse. Check
that the ball is also clean and moves freely.
3.
To remove the float shut-off, grasp the screen with
one hand and the connected tube with the other.Tilt
and pull the float screen assembly to pull it off the
barb on the tube.
4.
To install, place one hand on the tube, and then tilt
and push the float screen assembly over the barb
on the tube.
86400370 Manual Operators - EURO 24V Standard
