Windsor 10052480, Operator Instructions Manual

Page: 14 / 125

CONTROLS
GLIDE 86037550 01/09/07
3-7
3. ONE TOUCH SWITCH
This switch controls the scrub brushes and vacuum all in one touch.
To start scrubbing, press the one touch switch. The brush drive motors will turn on, the scrub deck will lower
to the "light scrub" position, the solution will flow at “two bars” rate, the squeegee will lower and the vacuum
will turn on. The information display window will show which functions are operating. If the direction control
pedal is in the neutral position for more than two seconds the brushes and solution flow will stop. If the one
touch switch is activated without brushes installed, the brush motors will stop, the scrub deck will rise, and the
brush pressure indicator will display error code 9000. To stop scrubbing, press the one touch switch. The
brush drive motors will turn off, the scrub deck will raise the solution flow will stop, the squeegee will raise
after a 15 second delay, and the vacuum motor will turn off. This delay is to clear the vacuum hose of
recovered solution.
4. BRUSH PRESSURE SWITCH
This switch controls the amount of brush pressure to the floor. There are 5 different pressure settings. To
decrease the amount of down pressure, press the top of the brush pressure switch (-). To increase the
amount of down pressure, press the bottom of the brush pressure switch (+). The information display screen
will show the amount of pressure.
NOTE: Press switch and hold momentarily each time to change brush pressure.
INFORMATION DISPLAY
INFORMATION DISPLAY
LESS PRESSURE
MORE PRESSURE