Hanging the fan
WARNING:
Please use all of the parts hardware and components provided by Wind River. The use of
other parts, hardware or components not supplied by Wind River with the fan will void the Wind River
Warranty.
REMEMBER
to turn off the power. Follow the steps below to hang your fan properly:
Step 1. Secure the mounting bracket to the ceiling outlet box using screws and washers included with
mounting hardware. (Fig.5)
Stpe 2. Lossen the two set screws from the top coupling of the motor assembly. (Fig 6)
Step 3. Remove hanger ball from downrod assembly by loosening set screw, removing the cross pin, and
sliding ball off rod. (Fig 6)
Step 4. Carefully feed fan wires up through the downrod (Fig 6). Screw the downrod into the coupling. Insert
the saftey bolt through the coupling and attach the nur.Tighten firmly. Tighten set screws.
Step5. Slip coupling cover, canopy cover, and canopy onto downrod (Fig.6).Carefully reinstall hanger ball
onto rod being sure that cross pin is in the correct position, set screws are tighten and wires are not twisted.
Step 6. Now lift motor assembly into position and place hanger ball into hanger bracket. Rotate until the
check groove has dropped into the registration slot and seats firmly. (Fig 7) Rod should not rotate if this is
done correctly.
Electrical connections
REMEMBER
to shut the power off at the circuit breaker or fuse box.
Follow the steps below to connect the fan to your house supply wires. Use the wire nuts supplied with your
fan. Secure the wire nuts by wrapping the connection with electrical tape.
Step 1. Connect the black (hot) wire from the ceiling to the black wire from the fan. Connect the white
(Neutral) wire from the ceiling to the white wire from the fan. (Fig 8)
Step 2. If your outlet has a ground wire (Green or Bare Copper) connect the fan ground wires (from hanger
ball and mounting bracket) to it; otherwise connect the fan ground wire wires from the hanger ball and
mounting bracket together. (Fig. 8)
Finishing the installation
Step 1. Remove one screw from the mounting bracket and loosen the other screw approximately 1/4 turn.
Step 2. Carefully raise the canopy up to the mounting bracket, and ensure the loosened screw is inserted
into the key hole on the canopy. Rotate the canopy clockwise. (Fig. 9)
Step 3. Secure the canopy by replacing the screw previously removed and tightening the screw previously
loosened. (Fig. 9)
Step 4. Place the canopy cover on the canopy, and rotate the canopy cover clockwise until it locks into
position. (Fig. 9)
Blade installation
Step 1. Attach the fan blades to the blade brackers by using three blade screws and fiber washers. Tighten
screws and fiber washers securely.(Fig.10)
Step 2. Attach the blade assembly to the fan motor assembly by tightening the two screws previously from
the package hardware. Repeat the process for the other blade assemblies. (Fig. 11)
3