9
Installation –
Mounting the Hood
1. Measure from range top to hood bottom and mark line A. (26”
minimum from range top) .
2. Plum and mark center line.
3. Mark mounting height line B. (15-1/8” from line A)
4. Mark mounting spread from C/L. (8-15/16”)
5. Fasten (2) M6 x 1-1/2” screws into studs on line B but do not
tighten all the way.
Note: Wood blocking may need to be
added behind the drywall if no studs are present. Wall
anchors may also be used but check local codes before
using wall anchors.
6.
Remove tape and (2) screws securing electronics mounting
bracket to hood. Reposition electronics mounting bracket as
shown in (FIG B. #3) and secure to motor housing using the (2)
previously removed screws.
7. Remove (2) screws securing electrical junction box to
electronics mounting plate. Remove junction box. (FIG. B #1)
8. Remove the mesh fi lter. Hang hood onto the mounting screws
and hand tighten each screw. (FIG. A #1) Secure third M6 x
1-1/2” screw with washer through inside of hood into wall for
extra support. (FIG. A #2)
9. Center and attach duct cover mounting bracket to wall just
below the ceiling or soffi t using (2) M6 x 1” screws. (FIG. A #3)
10. Install duct work and seal with aluminum duct tape*. Re-install
electrical junction box with cable lock and install the electrical.
(FIG. B #2)
11. Power up hood to verify all functions and check for leaks around
duct tape.
12. Place telescopic duct covers onto hood and extend inner (top)
duct cover upwards and secure to duct cover bracket using (2)
M3.5 x 8 screws.
13. Place glass canopy onto unit body, secure canopy by (4) 3/16”
x 1/4” screws through fi lter opening.
14. Reinstall stainless steel mesh fi lter.
* If using hood in recirculating mode you must secure the air
diverter plate onto wall before installing duct work and duct
covers. Refer to recirculating kit manual for more details.
15
1/8
”
Brackets are
pre-installed
8
15/16
”
26” Min.
A
B
3
1
2
Duct Cover Bracket
CAUTION: At least two installers are
required due to the weight and size of the
hood.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
!
Cable Lock
A cable locking connector (not supplied) might
be required by local codes. Check with local
requirements and codes, purchase and install
appropriate connector if necessary.
Cable Lock
2
1
3
Motor Housing
FIG. B
FIG. A
Summary of Contents for WCG300S
Page 2: ...www windcrestcnp com ...
