PSA /go
3
Using the PSA /go device
Important notice
Before you can start using your PSA /go device for the first time, you need to insert the supplied
battery pack into the device. Charge the device battery to the full capacity before use.
Suspending the PSA /go device
The device can be in two possible states. It can be:
- switched on
- in suspend mode
When the device is in the
‘Suspend mode’
, the display is switched off and the processor adopts a
sleep mode. All active processes will be suspended until the device is switched on again. The de-
vice looks as if turned off, but there are several significant differences.
By switching the device to the suspend mode the memory is not cleared. All the opened applica-
tions stop operating but will resume from the same point where they had been before entering in
the suspend mode.
To put the device to suspend mode, press the suspend button. Or press the ‘Start’ menu – ‘Sus-
pend’. The device also goes to suspend state after predefined time of inactivity. This time can be
configured in the Control Panel. (for information on its configuring, see the section
Software equip-
ment / Power Properties
)
To wake up the PSA /go device from suspend, press the suspend button.
Note:
After waking up the device, suspend is prohibited for a period of 10 seconds. During this pe-
riod the suspend button is not responding.
Resetting the PSA /go device
In case the software on the PSA /go device malfunctions or freezes, reset has to be used to bring it
to normal state. There are two types of reset – soft and hard.
The reset button is located aside the suspend button, lowered into the housing. Pressing the reset
for a short time invokes soft reset. Pressing it for longer than 3 seconds initiates hard reset. See
next table for actions and consequences for the memory.
