Installation
01750098304 D BA73R-1 LCD Display
–
Operating Manual 22
Software Installation
Install the appropriate device driver for the graphic controller installed in the
system. Select the resolution of 1024x768.
The installation of the touch screen comprises the allocation of resources for the
COM interfaces, too. For this, corresponding diskettes are available.
When installing the touch screen software and resource allocation (I/O address;
interrupt) for the COM interfaces, mind the following: During the installation there
may be conflicts in the I/O addresses and the interrupt. So take note of the
resources already allocated and read the instructions in the files, e.g. readme file,
of the installation diskettes very carefully. Then you can allocate the resources
and set the corresponding jumper configuration on the COM board.
N
OTE
:
Though the BA73R-1 generally offers good display performance, the types and
quality of the display adapter used in the host system can affect the display
quality.
Status LED information
The status LED information could be obtained from the LED on the bottom left of
the monitor. The table below describes the status of the monitor according to its
LED signal:
LED signal
Status
Green light
Monitor is ON.
Amber light
Monitor is OFF.
Blinking amber and green
light
Monitor is ON with no signal from the host
