5
Should you wash the Tomato Slicer in hot water, make sure to always rinse in warm or cold water
thereafter. Hot water may cause the slide board to expand, creating difficulty in pushing the pusher
assembly until the slide board returns to room temperature.
Minimize the use of alkaline cleansers as they may cause pitting and dulling of the cast aluminum body
finish.
1. To remove the pusher assembly for cleaning, remove the
thumb screws and the slide stop. Then pull the pusher
assembly off the end of the slide board.
2. The blade shield and blade assembly can be removed by
removing the hex bolts and washers.
3. The slide board can be removed by removing the mounting
screws underneath the tomoto slicer.
4. Clean parts and reassemble.
Note: To fully disassemble for parts replacement or
service, remove the acorn hex nuts and carefully remove
the pusher plates and spacers.
Remove the other screws to disassemble the handle part
from the guide plate.
Note: Blade assembly must be re-tensioned following
reassembly.
Tip: Loosen all hex nuts from hand blade shield before
attempting to fully remove.
CLEANING
Note: Hand washing unit is recommended as washing
in a commercial dishwasher will cause the all aluminum
parts to darken over time, this is normal, and does not
effect the general operation of the unit.
