Page 2 of 4
006085 5101A chair
Revision I Date 05-10-10
JWC
4. Slip the
Back Frame
over the
Seat Frame Rail
ends until the holes in
Back Frame
line up with the holes in
the Seat Frame Rails.
5. Insert the (2) screws you removed in step 2, into the aligned holes of the
Back Frame
and
Seat Frame
.
6. Tighten these screws firmly. Failure to install these screws MAY RESULT IN SERIOUS INJURY.
Operation of the Tray
7.
Tray Arms
are inserted into the
Tray Receiving Tubes
(under Armrests on chair). The
Tray
automatically
locks into the first position, depress the
Snap Button
(on Right Tray Arm) for 2 more positions.
NOTE: Left and right; As if you are seated in chair.
8. The Right
Tray Arm
is movable to compensate for minor variations in the width of the chair.
9.
Storing the Tray;
Insert the LEFT tray arm tube INTO the RIGHT tray receiving tube and the
Latch Button
will lock it into place. Allow the right side of the table to hang down vertically on the right side of chair (Left &
Right; as if you are seated in chair).
10. To make the tray permanently “non-restraint”, remove the
Snap Button
of the
Right Tray Arm.
Wrinkles in Vinyl –
Storage and shipping can cause wrinkles of the vinyl on your Winco chair. This is normal.
Please allow 1-2 weeks at room temperature (approx. 70 degrees) to allow for vinyl to expand back to original
appearance.
Periodically recheck tightness of all screw and bolts, and
never use the chair arms or tray as a seat or the tray as
a restraint.