6
Operation
Preparation
1. Place Water Boiler on a flat leveled surface.
2. Remove locking lid by turning counterclockwise.
3. Fill Water Boiler with water up to the "MAX" indicator inside.
4. Plug the unit into 120V or 220V power source (as noted on serial
tag) and turn ON. The heating indicator light will turn on and
the water will start to heat up. This will continue until the unit
automatically switches to its warming state.
WARNING: DO NOT attempt to open the lid while the unit is
operating to avoid the risk of burning due to the hot water.
5. Once warming indicator light turns ON, the water can now be
dispensed. Use the faucet to dispense the water.
It is recommended to clean the Water Boiler before the first use. To
clean and protect the urn, the manufacturer used food grade cleaning
oil on the product.
1. Fill the Water Boiler to “MAX” level with water, boil, discard the
water, and rinse. Repeat the procedure several times to remove
any dust, residues, etc., from the Water Boiler.
Burn Hazard.
When in operation, the
appliance surfaces will be HOT!
Please take extreme caution.
Risque de brûlure.
En fonctionnement, les surfaces de
l'appareil seront CHAUDES!
S'il vous plaît prendre une extrême
prudence.
USE CAUTION WHEN
TOUCHING THE UNIT.
Ne touchez pas le liquide chaud
ou les surfaces de chauffage
lorsque l’appareil chauffe ou en
fonctionnement.
WARNING
AVERTISSEMENT
HOT
Safety Precautions
Before installing and operating this equipment be
sure everyone involved in its operation are fully
trained and aware of all precautions. Accidents
and problems can result from a failure to follow
fundamental rules and precautions.
•
A WINCO® Approved Recommended Qualified Service Technician
should carry out repairs if necessary. Do not remove any
components or service panels on this product.
•
Before handling, allow the equipment to cool after use.
•
Before cleaning, switch off power and disconnect power cord
from the outlet.
•
Do not immerse unit in water or use hose to clean.
Ne jamais immerger l'appareil dans l'eau ni utilisez un jet
d'eau pour le nettoyer.
•
If the power cord is damaged, it must be replaced by a WINCO®
Approved Recommended Qualified Service Technician in order to
avoid a hazard.
THIS EQUIPMENT MUST ONLY BE SERVICED BY AN AUTHORIZED AGENT.
To maintain the appearance and increase the service
life, clean the water boiler daily.
Clean all surfaces before using the appliance. Also
clean after each day’s operation; however, the unit
may require more frequent cleaning, depending on
the volume of production.
Cleaning, Care & Maintenance
•
Switch power off and disconnect from the outlet before cleaning.
•
Unplug the unit when not in operation.
•
Allow unit to cool before attempting to clean.
•
The interior of the water boiler should be cleaned periodically with
warm, soapy water and soft cloth.
•
The exterior of the unit may be cleaned by carefully wiping with a
damp cloth
•
DO NOT
immerse the unit in water.
•
DO NOT
clean with a pressure washer.
