6
Operation: EDM-1
Operation: EDM-2
Removing the Tray
Before using this equipment it must be cleaned and dried thoroughly. Clean all surfaces before use. Failure to clean
surfaces before using the unit could cause food contamination.
• Always unplug the unit after every use and before cleaning. Unplug the unit when not in operation.
• Allow merchandiser to cool before attempting to clean.
• The interior heated display merchandiser should be cleaned periodically with warm, soapy water on a cloth. The exterior of the unit may be
cleaned by carefully wiping with a damp cloth. The glass may be cleaned with a glass cleaner.
• The pizza/pretzel rack is removable from this unit for ease of cleaning.
• Do not immerse the device completely in water to clean. The appliance should also NOT be cleaned with a water jet.
Warning: The interior of the unit will be hot after use. Exercise caution when handling cooking utensils and cookware.
NOTE: Proper cleaning instructions must be followed; otherwise, operation of the unit may be seriously impaired. Do not
wash parts in an automatic dishwasher.
WINCO authorized service personnel must perform any other servicing.
Cleaning & Maintenance
Tools needed: Philips Head Screwdriver
1. Clean any food off the rack.
2. Use Phillips head screw driver to
unscrew bolt at top of the rack.
3. Place nut and bolt aside for safe
keeping.
4. Push rack upward slightly to
free it from the bottom center
alignment hole and tilt the top
toward the door opening.
5. Remove from the unit.
1. Plug in the power cord and turn on the power.
2. The ‘LO H2O’ alarm will flash on the display until water has
been added to the water tank.
3. Set desired temperature.
• Press the temperature button and the display will show “tSP”
• Use the up or down arrow keys to select the desired
temperature
• Wait 15 seconds and the number will be stored and the
display will return to current temperature.
4. Set desired humidity.
• Press the humidity button and the display will show “hSP”.
• Use the up or down arrow keys to select between 1 (Least
Humid) and 5 (Most humid).
• Wait 15 seconds and the number will be stored and the
display will return to current temperature.
5. Once preheated, open door.
6. Rotating tray should stop and be able to still turn in one
direction manually.
7. Place pizza or pretzels as desired into the unit.
8. Refill water as needed for desired humidity. A full tank should
last 3-6 hours dependant on use.
Draining the Unit
1. Remove all food and debris from the interior of the unit.
2. Remove the rack from the unit.
3. Place a bucket/bowl to catch the water under the drain in the
rear of the unit.
4. Turn the drain handle and allow unit to empty.
5. Close drain before adding new water.
6. Cleaning solution may be run through the water tank. Excess
water is needed to flush the cleaning solution through the
line and tank until drained water is clear.
1. Plug in the power cord.
2. Fill water well with water until full, replace cover.
3. Turn on unit.
4. Set desired temperature.
5. Turn on light and motor, if desired.
6. Once preheated, open door.
7. Rotating tray should stop and be able
to still turn in one direction manually.
8. Place pizza or pretzels as desired into
the unit.
9. Refill water as needed for desired
humidity.
NOTE:
Drain either unit before moving to new location
