Winco EDM-1K, Operating Instructions Manual

Page: 8 / 16

8
WARNING: The interior of the unit will be hot after use.
Exercise caution when handling cooking utensils,
cookware / pans.
NOTE: Proper cleaning instructions must be followed,
otherwise operation of the unit may be seriously impaired.
Do not wash parts in an automatic dishwasher.
Safety Precautions
Before installing and operating this equipment be
sure everyone involved in its operation are fully
trained and aware of all precautions. Accidents
and problems can result from a failure to follow
fundamental rules and precautions.
• A WINCO® Approved Recommended Qualified Service Technician
should carry out repairs if necessary. Do not remove any
components or service panels on this product.
• Before handling, allow the equipment to cool after use.
• Before cleaning, switch off power and disconnect power cord
from the outlet.
• Do not immerse unit in water or use hose to clean.
Ne jamais immerger l'appareil dans l'eau ni utilisez un jet
d'eau pour le nettoyer.
• If the power cord is damaged, it must be replaced by a WINCO®
Approved Recommended Qualified Service Technician in order to
avoid a hazard.
THIS EQUIPMENT MUST ONLY BE SERVICED BY AN AUTHORIZED AGENT.
To maintain the appearance and increase the service
life, clean the heated merchandiser daily.
Clean all surfaces before using the appliance. Also
clean after each day’s operation; however, the unit
may require more frequent cleaning, depending on
the volume of production.
Cleaning, Care & Maintenance
• Switch power off and disconnect from the outlet before cleaning.
• Unplug the unit when not in operation.
• Allow merchandiser to cool before attempting to clean.
• The interior of the heated display merchandiser should be cleaned
periodically with warm, soapy water and soft cloth.
• The exterior of the unit may be cleaned by carefully wiping with a
damp cloth. OK to use glass cleaner on the glass.
• The rack is removable for easy cleaning.
• DO NOT
immerse the unit in water.
• DO NOT
clean with a pressure washer.
Burn Hazard.
When in operation, the
appliance surfaces will be HOT!
Please take extreme caution.
Risque de brûlure.
En fonctionnement, les surfaces de
l'appareil seront CHAUDES!
S'il vous plaît prendre une extrême
prudence.
USE CAUTION WHEN
TOUCHING THE UNIT.
Ne touchez pas le liquide chaud
ou les surfaces de chauffage
lorsque l’appareil chauffe ou en
fonctionnement.
WARNING
AVERTISSEMENT
HOT
Removing Lime/Mineral Deposits
1. Switch the power to OFF and unplug power cord. Allow the
unit to cool.
2. After the unit has cooled, drain the unit.
3. Fill the water reservoir with a mixture of 70% water and
30% white vinegar only.
4. Plug in and turn the unit on.
5. Set both the air temperature and humidity to their highest
settings and allow it to run for 30 minutes.
6. Switch the power OFF and unplug the power cord again,
allow to cool.
7. Drain the unit to empty the deliming solution from the
reservoir.
8. Continue to fill and drain the water reservoir with clean
water until the deliming solution is rinsed through and the
reservoir is clean.
9. Replace the rack.
10. Plug the unit in and fill reservoir with 1 gal (4 Qts) of
DISTILLED WATER or PURIFIED WATER ONLY.
NOTE: The amount of sediment content in the water
determines how often it will be necessary to delime.