Shower control
SanTec PROOF S6
25
EN
PROOF S6
17
18
Initial start-up
17.
Insert the front plate at an angle and apply some pressure
while turning it to the left to align it horizontally.
18.
Arrest front plate by fastening the locking screw at the
lower right.
19.
Open the main water valve and turn on the power supply.
20.
Perform a system test.
Make sure that you are within the sensor range when
performing the system test. The illuminating icon begins
to pulse slowly to indicate this. If you are unable to stand
within the sensor range due to space restraints, place an
object or body part, such as your hand, 10–15 cm from the
infrared shower monitoring sensor (located right below the
temperature setting) for the entire duration of the system
test. If not, it may not be possible to turn the shower on or
immediately off again.
20
ATTENTION!
It may be necessary to ad-
just the range in confined
spaces such as in a shower
cubicle (see page 21).
!
19
