© by WilTec Wildanger Technik GmbH
Seite 3
http://www.wiltec.info
Installing on a drywall construction
For a safe drywall mounting please use two wooden beams/rails placed at least at a 30 cm
distance from each other.
1. Use a metal detector to find two adjoining rails and mark their position.
2. Place the wall plate on the desired place with the help of a second person and the level.
3. Mark right and left the upper, middle and lower oblong holes, that are above the beams or rails.
4. All in all 4 or 6 places have to be marked.
5. First pre-drill a 3 mm hole in the wall.
6. Assisted by a second person, position the wall plate on the wall and place the oblong holes over
the drilled holes so that they match.
7. In each hole insert a hex lag bolt with washer.
8. Tighten the hex lag bolts clockwisely.
Beware:
Do not fasten the bolts too tightly in order to avoid causing damage to the wall.
Beware:
Do not let go of the wall plate, before it is properly fixed.
Installation on a concrete wall
Attention: concrete rawl wall plugs or special rawl plugs must be used from the local ironware
trades.
1. First place the wall plate on the wall with the help of the bubble level.
2. Mark right and left the upper, middle and lower oblong holes.
3. First drill bores with a 10 mm
– masonry drill.
4. Insert in every hole a concrete rawl plug and if necessary hammer it carefully in the borehole.
5. When the rawl plugs are inserted, place the wall plate over them so that the position of the
rawl plugs coincides with that of the oblong holes.
6. Screw the hex lag bolts in the rawl plugs, tighten them lightly and screw tightly only after all
hex lag bolts have been already inserted.
Installation of TV-screen
1. This kit includes different screws with different lengths and diameters for an optimum mounting.
2. Put the TV-Screen on a soft surface and search the threaded holes on the back.
3. Determine the depth of the drilling by using a straw or toothpick.
4. If your TV-Screen has a concave back, use the spacer.
Tip: use the smallest possible spacer, to keep the distance screen - mounting support as small as
possible.
5. Insert the spacer between the screen and the mounting support.
6. If a smaller screw (M4, M5 or M6) is used, please use a washer for every screw for improving the
stability.
Final installing
Fix the mounting support on the screen, by placing the holes of the mount support over the threaded
holes of the screen
’s backside.
Insert the suitable screws with washers in the holes and screw them in.
1. Screw in tightly with a cross-recess screwdriver.
Attention:
The installing has to be carried out by at least two
qualified people
.
2. To complete the installing, hook both perpendicular brackets into the backside of the screen, in
both horizontal cross bars.
3. When hooking into, make sure that the safety screws of the mount are not screwed in.