GENERAL INTRODUCTION
The 6V/12V or 12V/24V battery charger has the feature of convenient operation, stable perfor-
mance and reliable safety. The charger can be switched between 6V and 12 V or 12V and
24V, so it can charge for 6 V and 12 V or 12V and 24V accumulators.
If battery is over-charged, the charger will keep it at normal current output.
The fuse will break and the charger will be switched off upon short circuit, overload or if re-
verse polarity happens. Battery charger will work normally after changing the fuse.
The battery is well protected with stable current output, and requires only 3-4 hours to charge
the battery.
Indication of charging: the charger has 6 pilot lamps with different percentages. Different
lamps show the charging status. When pilot lamps are lightened of 100%, the charging
process is finished.
TECHNICAL PARAMETERS
Model
6 V and 12 V
12 V and 24 V
Rated Input
230 V, 120 W
230 V, 195 W
Frequency
50 Hz
50 Hz
Rated Output
6VDC 6.5 A(Hi) 3.5 A(Lo)
12VDC 9.5 AMP
12VDC 6.5 A(Hi) 3.5 A(Lo)
24VDC 6.5 AMP
Pack Value
10AMP/rms
15AMP/rms
OPERATION INSTRUCTIONS
1) The operation is convenient, clip the red clamp on positive pole of the accumulator (indicated with
“+”) and clip the black clamp on negative pole (indicated with “-”), then plug in power source, the
accumulator will be charged.
2) Battery Charger: Select the voltage you need, depending on battery and battery charger. Switch
the loading speed according to the need.
IMPORTANT MATTERS
Apply: Lead-Acid Battery
Battery Capacity: 10-80 ARH with 6V/12V edition and 10-100 ARH with 12V/24V edition.
1) It must work on AC230V condition.
2) The red clip and black clip should not be touched during charging to avoid short circuit.
3) Please put the charger at draughty and dry place, avoid direct sunlight.
© by WilTec Wildanger Technik GmbH
Seite 8
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de