Measure the gap between A and B precisely and
mark it (this gap is dependent on the size of the
product).
Drill holes as shown in the illustration and mount
the holding device.
Connect the hose to the valve (H left, C right).
Open the valve and place the product on the
holding device. The mounting is then finished.
Mounting notes
Do not install the rain shower beneath the heating element. The horizontal distance should be
more than 30 cm, as steel heats up very fast.
Remove all pollutants to guarantee the flow and to prevent any blockades.
Read the instructions thoroughly. A wall mounting offers the most ideal method of mounting.
Minimal deviation of the measurements are alright, as long as the device can be mounted to
the holding device securely.
The direction of the G ½ inch elbow connection is determined by the height of the water pipes
in the wall and the mounting height. The right positioning enables the HC hose to be in a
straight position and thus the use is improved.
When the hand shower bracket is being installed, the front should be installed via hand and
the nut behind it should be tightened, as the surface might be scratched by the hand shower
bracket.
Please remove the protective foil after mounting. The protective foil protects the rain shower
during mounting against pollution or damage of the surface.
© by WilTec Wildanger Technik GmbH
Item 61836, 61837
Page 4
http://www.WilTec.de
http://www.aoyue.eu
02 2021
-1
