© by WilTec Wildanger Technik GmbH
Item 61492
Page 5
05 2021
-1
Commissioning
Connecting
Connect the welder to the heating element. Make sure that the heating mandrel is firmly tightened,
otherwise an irregular heat transfer can occur. Prepare the pipe ends before welding. The joint surface
of the pipe must be worked on according to the pipe m
anufacturer’s instructions.
Turning on the power
Turn on the power and make sure that the green lamp is on. The red lamp then starts to light up and
indicates that the heating process has started. When the welding temperature is reached, the red lamp
goes out and the green one starts to light up again. The device is now ready for use.
Welding pipes
•
Quickly and axially push the pipe and fitting onto the heating mandrel and the socket attached
to the heating element. Fix them during the warm-up time.
•
After the warm-up time has elapsed, suddenly separate the pipe and fitting from the heating
mandrel and socket and push them immediately, without twisting them, up to the mark. Insert
both to the required depth until the flange is visible on the joint.
•
Hold the compressed connection fixed and allow it to cool.