Caution
: Never use an extension cord with this product. Use an additional air hose instead of
an extension cord to avoid power outages and permanent engine damage. The use of an ex-
tension cord will void the warranty.
Technical Data
Power
750 W
Input Voltage
230V ~ 50Hz
Rated Speed
1415 rpm
Displacement
98 l/min
Max. working pressure
8 bar / 115 PSI
Tank Capacity
24 l
Net Weight
20 kg
User Guide
Start the compressor by turning the switch to
“on”.
If the compressor fails to start, please re-
lease the air of the tank till the pressure decreases to 4 bar (0.4 Mpa). Then the compressor
will start.
In Order to stop it, turn the switch to
“off”
, then cut the power supply off and the machine will
stop running.
There is a safety valve installed on the switch. When the pressure in the air vessel exceeds 8
bar (0.8 Mpa), the safety valve will start an alarm and release air. When the alarm turn son,
please check the pressure switch. Make sure the pressure switch works under the rated work-
ing pressure.
When using the oil-water separator: After switching the compressor off, please use your finger
to press the needle below the oil-water separator to discharge the dirty water within the separ-
ator.
The air pressure can be adjusted by the button on the oil-water separator. Turn the knob
clockwise to increase the air pressure and turn it counter-clockwise to reduce the air pressure
until the air source has turned off.
Note:
When turning the knob has reached the end, do not force it to turn even more.
Otherwise it will cause damage.
If you want to adjust the working pressure of the pressure switch, please remove its cover and
adjust the turning screw within. Turn it clockwise to increase the air pressure and turn it
counter-clockwise to decrease it
Note:
Always pull the plug to disconnect the compressor from the power supply, before any
kind of adjustments or repairs/ maintenance work is carried out.
© by WilTec Wildanger Technik GmbH
Artikel 61017
Seite 4
http://www.WilTec.de
http://www.aoyue.eu
10 2020
-1
