7. Assemble the front ends of the hitch mount
arms together using two M8×30 hex bolts
(6)
and
M8 hex lock nuts
(1).
Do not tighten yet.
8. Assemble the hitch brackets
(3)
to the top and
bottom of the hitch mount arms using two M8×50
hex bolts
(5)
and M8 hex lock nuts
(1).
Do not
tighten yet.
9. Assemble the Ø10 hitch pin
(4)
through the
hitch brackets and secure it with a Ø3 hair cotter
pin
(2).
10. Tighten the bolts and nuts assembled in the
previous steps in the following order: 8 – 7 – 3 – 4
– 5 (slightly re-loosen afterwards) – 6.
11. Assemble the axle bracket
(1)
on the outside
of the angle brackets using two M8×20 hex bolts
(3)
and M8 hex lock nuts
(2).
The ends of the axle
bracket must point as shown in the figure. Tighten
and then slightly re-loosen the bolts and nuts.
12. Assemble the wheels to the axle bracket us-
ing two shoulder bolts
(2)
and two M10 hex lock
nuts
(1).
Tighten.
13. Fasten ten spring tines
(4)
to the square holes
in the bottom of the tine shield. Use a M8×25 car-
riage bolt
(5),
Ø8 big flat washer
(3),
Ø8 lock
washer
(2)
and M8 hex nut
(1)
for each spring
tine. Tighten.
NOTE:
Spring tines must seat between dimples.
14. Assemble the spring align wires
(1)
through
the front and rear rows of spring tines, passing
the wires in between the hitch mount arms and
the tine shield. Bend the ends of the wires to se-
cure them.
© by WilTec Wildanger Technik GmbH
Item 51705
Page 7
http://www.WilTec.de
http://www.aoyue.eu
01 2021
-1