WilTec 51484, Operation Manual, Page: 4 / 5

© by WilTec Wildanger Technik GmbH Item 51484 Page 4
http://www.WilTec.de
http://www.aoyue.eu 09 2021 -1
http://www.teichtip.de
2. Mounting the upright supports to the
wall studs: Install 2 wall studs that are
32
″ to 48″ apart (measured from their
centre). Make sure the holes are on the
same level of height. Pre-drill the
2 marked holes using a
3
⁄
16
″ drill bit (M:
32
″ to 48″ centres).
IMPORTANT NOTES:
a) The unit MUST be installed on wall
studs. Do not use wall anchors for
mounting directly to sheet rock.
b) Do not overtighten the lag screws
(max. 13,6 Nm/10 ft.lbs.). They only
need to be fully seated.
3. Mount parts (1) and (2) with expan-
sion screws (5) (not supplied due to dif-
ferent standard). Do not fully tighten the
top screws at this time. The brackets
must be at the same level. Make the re-
maining two holes and fasten them with
screws
(5). Fully tighten all screws.
4. Attach the round tubes: Insert
tubes
(4) into tubes (3), fasten them to
the brackets (1, 2) with bolts (6), in the
position that best supports your tyres.