© by WilTec Wildanger Technik GmbH
Seite 8
http://www.wiltec.info
Hardware kit:
x2pcs 2” Wood
Screw (A)
x4pcs 3/4” Spacer
(D)
x4pcs M4x12mm
Philips
Head
Screw (B)
x1pc Bubble Lev-
el System (E)
x4pcs
M4x30mm
Philips
Head
Screw (C)
x1pc S=4mm
Allen Wrench (F)
x2pcs Concret
anchor
（
H
）
x1pc S=3mm
Allen Wrench (G)
Tools Required:
Phillips Head Screw driver
Stud finder for drywall installation
Electric drill and 1/4” (8mm) masonry bit for concrete/brick installation
Note: You need to insert the bubble level system when you install the wall plate and take it
away fate you finish installation.
Step 1
– Mounting the Wall Plate
Wood Stud Installation
Note: Using a wood stud finder, locate the stud centers behind
the wall. Once found, make a pencil marking on the center of
the wood studs. Once the mark is made, it is strongly recom-
mended that a pilot hole be drilled with a 1/8” drill bit.
1. Place the wall plate against the wall with the hook towards the
bottom.
2. Secure the wall plate using one 2” wood screw (A).
3. Using the bubble level system (E), carefully adjust the wall plate
until it is level.
4. Attach the remaining 2” wood screw into the wall plate and tighten.