Artikel 75998 - Stand: 29.10.2008
Fault tracing Motorcycle Type 338A/998A
Installations problems and their causes:
Problem
Cause / Elimination
The alarm system shows no function
The supply voltage is not connected / please check the contact of the red
and of both black cables
Are all the cables connected? Plus and minus alone are not enough to test
the system!
The alarm system cannot be activated,
or the alarm is triggered immediately when enabled
The alarm system detects a false signal / the orange cable is incorrectly
connected and has still +12V when armed/activated
By engine remote start the motorcycle won’t start
(starting motor rotates itself)
The cables (orange) an ACC (ignition switch positive) is not properly
connected / check the cabling.
Beim Motorfernstart startet das Motorrad nicht
(Starter dreht nicht)
The starter relay is not positively switched but negatively / Connect
another relay to the earth side of the starter relay which is activated by
remote start via blue cable (of the alarm system).
The alarm is triggered but the siren does not go off
The connector to the alarm siren has no contact / plug in the connector
When the remote control is activated, the blinkers do not
flash
The battery of the motorcycle could be discharged please change the
battery to ensure the alarm function.
If you have checked the whole cable layout and read these instructions and still cannot put the alarm system into operation, note down
which cable you have connected and send us an Email, as well as a description of the malfunction.
Send your Email-support to:
, without a first contact via Email
no (!) telephone support
is provided!
By telephone and written enquires please always specify your customer and order number. In case you did not purchase the alarm
system from WilTec Wildanger Technik GmbH, please contact your seller.