ENGLISH
13
Safety Guidelines
Verify that both the Outside Antenna and the adapter extension cable are connected to the Signal Amplifier
before powering up the Signal Amplifier .
Use only the power supply provided in this package . Use of a non-Wilson Electronics products may damage
your equipment .
RF Safety Warning: Any antenna used with this device must be located at least 8 inches from all persons .
AWS Warning: The Outside Antenna must be installed no higher than 10 meters (31’9”) above ground
This is a CONSUMER device.
BEFORE USE
, you
MUST REGISTER THIS DEVICE
with your wireless provider and have your provider’s consent. Most wireless
providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are
unsure, contact your provider.
In Canada,
BEFORE USE
you must meet all requirements set out in ISED CPC-2-1-05.
You
MUST
operate this device with approved antennas and cables as specified by the manufacturer. Antennas
MUST
be installed at
least 20 cm (8 inches) from (i.e.,
MUST NOT
be installed within 20 cm of) any person.
You
MUST
cease operating this device immediately if requested by the FCC (or ISED in Canada) or licensed wireless service provider.
WARNING
. E911 location information may not be provided or may be inaccurate for calls served by using this device.
This device may be operated
ONLY
in a fixed location (i.e..may operate in a fixed location only) for in-building use.
FOR MORE INFORMATION ON REQUIREMENTS SET OUT IN ISED CPC-2-1-05, SEE BELOW:
http://www .ic .gc .ca/eic/site/smt-gst .nsf/eng/sf08942 .html
BU-GDE000210-FR-001-010220.indd 13
BU-GDE000210-FR-001-010220.indd 13
1/7/2020 9:44:26 AM
1/7/2020 9:44:26 AM
