6.
Place two stud straps through holes on part A of fi rst bracket pair and attach fi rst
bracket pair to pole assembly using washers and Nylock nuts.
7.
Place two stud straps through part A of second bracket pair and thread through other
side of pole assembly making sure to allow enough room to place washers and nuts. Tighten
second bracket assembly to pole assembly.
8
.
Determine whether you are utilizing the 10° tilt.
a.
If you are NOT using the tilt feature, close the bracket assemblies and fasten the tops
together using the 1⁄4” screws.
b
.
If you are utilizing tilt, Attach Part T to the top of Part A using (2) 1⁄4” screws, by
inserting the screws from the outside through hole on fl ange into weld nut on the arm.
Repeat on other side. Close the bracket assemblies & fasten the tops using 1/4” screws.
9.
Place plastic collars into the top and bottom of receiving tube on Part M.
10.
Place the pole assembly with A & B brackets attached upright and insert the top of the
pole through the receiving tube on Part M (ceiling mount bracket).
11.
Push the Mounting Pole Pin (located in bagged hardware) through the hole in the top
of the Pole assembly. Place Mounting Pole Cap over Pin and pole being sure it seats fi rmly.
***At this point you may want to “dry fi t” Part C into part B to familiarize yourself
with the hanging mechanism. ***
12.
Attach parts D – fl at side down - to back of each TV using hardware specifi c to your TV.
(Hardware not included for this step.)
13.
Attach part C with the fl at side down and the notch oriented at the top to parts D using
(2) two 1⁄4” screws and washers for each TV.
14.
Install the completed ceiling mount assembly to the ceiling using the appropriate hard-
ware and method for your particular needs.
15.
With the WPCM-2 properly and safely installed to the ceiling, hang each TV by aligning
Part C with the receiving tabs on Part B and gently lower into the bracket assembly.
16.
Insert security screw into top of Part C, securing it to B.
17.
Determine that the assembly is at the desirable position and tighten the set screw
located near the bottom of the receiving tube on the ceiling mount bracket.
Pole assembly is the
pole & channel brackets
Secure stud
straps & pole
assembly
Photo C
Pole assembly with TV Bracket
attached - side view