Wilson Electronics WPCM-2, Quick Start Manual

Page: 1 / 2

Before you begin:
It is advised to have the assembled unit
mounted to the ceiling by a professional. It would be helpful to
have two people assemble the unit.
Although this unit is designed to hold up to 300 lbs, it is
imperative that the fi nished unit is mounted securely to the
ceiling. Ceiling installation hardware must be determined
on an individual basis and therefore is NOT included.
This item ships in three boxes. All three boxes contain bagged
hardware.
Instructions for a WPMSS are included. Please do not follow
those instructions but you may fi nd the parts diagrams helpful.
Qty Description Part
1 Ceiling Mount Bracket M
1 Pole P
2 Upright Bracket A (see diagram) A
2 Upright Bracket B (see diagram) B
2 Center Brackets C
4 TV Brackets D
4 Arms for 10 degree Tilt T
4 Stud Straps S
2 “U” Channel Brackets U
18 1⁄4” Screws
18 Washers
8 3” Screws & Washers
4 3” Wood Stud Phillips Head Screws
4 Small Washers
1 Tube Plug
2 Plastic Collars
1 Mounting Pole Pin
1 Mounting Pole Cap
1 Set Screw (10/32 x 1⁄4”)
1 3/8 x 2.5” long Hex Head Bolt
1 Nylock Nut for 3/8 x 2.5” Bolt
8 Nylock Nuts 5/16 for stud straps
WPCM-2 Dual Monitor Ceiling Mount
H. Wilson Company 555 West Taft Drive South Holland, IL 60473
Phone (800) 245-7224 E-mail sales@hwilson.com
Instructions:
1.
Remove all items from boxes and identify all parts.
2. Review these instructions completely before proceeding.
3. Make sure that Parts A & B are oriented in the same
direction as the diagrams for A & B. Attach Part A to Part B
using (2) 1⁄4” screws at the bottom of the mount by inserting
the screws from the outside through the hole on the fl ange into
the weld nut. (***See Part B diagram of WPMSS Instructions)
**** If you are not using the 10° tilt, proceed to Step 5. ****
4.
Repeat steps 3 for second pair of brackets. Set one pair
aside.
5. Determine which of the three height options to use and
attach both Parts U to Part P using the silver 2 1⁄2” long bolt and
Nylock nut. Tighten. Place black tube plug into the bottom (end
with no hole) of Part P.
Stud Straps
Stud Straps
Part ‘T’
A
A
B
B
B
A
Pole
‘U’ Channel
Brackets
Large Silver Bolt attaches
U Channel brackets to pole