7
9. NOTES & WARNINGS
WARNING:
Verify that both the outside antenna and the inside antenna are connected before
powering up the amplifi er.
WARNING:
Do not place the outside antenna in the vehicle without turning the amplifi er off. For
example, when at a car wash.
This will cause damage to the amplifi er.
WARNING:
The outside antenna must be mounted with a separation distance of at least 17 inches from
any of the vehicle occupants or nearby persons and must not be co-located or operating in conjunction
with any other antenna or amplifi er. Use of a cellular amplifi er with antenna gains higher than 6.12 dBi
is in violation of FCC regulations for which the offender is fully liable. All Wilson Mobile Antennas
are 6.12 dBi or less.
WARNING:
The inside antenna must be mounted with a separation distance of at least 1 inch (2.5 cm)
from all persons and must not be co-located in conjunction with any other antenna or amplifi er.
WARNING:
Do not plug the amplifi er directly
into
the phone using a phone specifi c adapter.
WARNING:
Do not use a glass mounted antenna with a mobile wireless amplifi er
WARNING:
Use only the DC Power Supply that comes with the amplifi er, or a replacement supplied
by Wilson.
Operation is subject to the following two conditions: (1) This device may not cause interference,
and (2) this device must accept any interference, including interference that may cause undesired
operation of this device.
Leaving the amplifier on in an unused vehicle for days may drain your battery. This can be
avoided by plugging into an ignition switched power source.
The Manufacturer’s rated output power of this equipment is for single carrier operation. For
situations when multiple carrier signals are present, the rating would have to be reduced by 3.5
dB, especially where the output signal is re-radiated and can cause interference to adjacent band
users. This power reduction is to be by means of input power or gain reduction and not by an
attenuator at the output of the device.
In order to prevent excessive input levels from distorting or otherwise overdriving this amplifier,
the maximum uplink RF output is 35 dBm, and the maximum downlink RF output is 10 dBm.
When an input tends to create greater than these maximum levels, a switching circuit will reduce
the RF output by as much as 50 dB.
The voltage and current into the final amplification stage are:
TX: 6 V DC 3 A
RX:
3.6
V
DC
50
mA
