5
6
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.
About Wilson Electronics
Wilson Electronics, Inc . has been a leader in the wireless communications industry for over 40 years .
The company designs and manufactures Signal Boosters, antennas and related components that
significantly improve cellular phone signal reception and transmission in a wide variety of applications,
both mobile (marine, RV, vehicles) and in-building (home, office, M2M) .
With extensive experience in antenna and Signal Booster research and design, the company’s
engineering team uses a state-of-the-art testing laboratory, including an anechoic chamber and network
analyzers, to fine-tune antenna designs and performance . For its Signal Boosters, Wilson Electronics
uses a double electrically shielded RF enclosure and cell tower simulators for compliance testing .
Wilson Electronics Signal Boosters feature patented Smart Technology ™ that enables them to
automatically adjust their power based on cell tower requirements . By detecting and preventing
oscillation (feedback), signal overload and interference with other users, these Smart Technology ™
Signal Boosters improve network cell phone areas without compromising carrier systems .
All products are engineered and assembled in the company’s 55,000-square-foot headquarters in St .
George, Utah . Wilson Electronics has product dealers in all 50 states as well as in countries around the
world .
Warning: Do not plug in the power supply until the Outside Antenna cable is attached to the Sleek .
Warning:
RF Safety:
The Sleek cradle/Signal Booster must not be used in conjunction with any
other antenna or Signal Booster .
Warning
RF Safety:
The FCC requires that a cell phone with cradle attached may only be used
with the cradle mounted as illustrated in this installation guide . A cell phone held near
the ear must be without the cradle attached .
Warning:
RF Safety:
All Inside Antennas used with this Signal Booster may not have gain (less
cable loss) that exceeds 15 dBi and must be located at least 8 .5 inches from all people .
Outside antennas may not have gain that exceeds 3 .4 dBi (less cable loss) and must
be located least 9 inches from all people . All antennas shown on page one meet these
requirements .
Warning:
DO NOT use phone covers that have chrome or any other metallic surface . It may block
cellular signals .
Warnings
This device complies with part 15 of the FCC Rules . Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or modifications made that are not
expressly approved by Wilson Electronics could void authority to operate this equipment .
