Wilson Electronics BAIARDO L, Operation Manual, Page: 8 / 12

BAIARDO L OPERATION MANUAL
BAIARDO L OPERATION MANUAL
13 14
F1: CALIBRATE MACHINE
After holding setting button for 3 seconds, the first setting
displayed is calibration.
Steps to calibrate:
1. To calibrate the machine, a tension meter must be
mounted. Start from screen above.
2. Pull a string. Check the value on tension meter.
3. Adjust tension displayed on machine with UP/DOWN
buttons to match tension on string tension meter.
4. Push ENTER to confirm.
Now, display shows:
5. Pull a string. Check the value on tension meter.
6. Adjust tension displayed on machine with UP/DOWN
buttons to match tension on string tension meter.
7. Push ENTER to confirm.
Now, display shows:
8. Pull a string. Check the value on tension meter.
9. Adjust tension displayed on machine with UP/DOWN
buttons to match tension on string tension meter.
10. Push ENTER to confirm.
Now, display shows:
11. To confirm and finish calibration, push ENTER button.
Calibration is now complete.
After you adjust all settings, the computer will automatically
calibrate your machine based on the 4 numbers you gave it.
Your machine will now be calibrated to your device.
* Note: In KG mode, displayed numbers will be 10, 20, 30 and
40 respectively.
7.2 B.E.S.T.™ MODE
F2: RESET TO DEFAULT FACTORY
CALIBRATION
To go to next setting after calibration, touch UP button once.
Screen will display:
This function resets the calibration of machine to original
factory calibration.
To do so on this screen, simply touch ENTER. The machine is
now reset to original factory calibration.
F3: SKIP – RESERVED FOR FUTURE USE
To go to next setting, touch UP button once. Screen will display:
This function is reserved for future use.
F4: ADJUST TOUCH BUTTON SENSITIVITY
To go to next setting, touch UP button once. Screen will display:
This function shows and adjusts sensitivity of all touch buttons.
WARNING: do not adjust this setting unless sensitivity of touch
panel makes machine hard to use.
To adjust sensitivity, use the UP/DOWN buttons. The range of
sensitivity is on a scale of 0 – 7. For least sensitive setting, select
7. For most sensitive setting, select 0. If set at 0, the touch buttons
may be so sensitive that they only work with an airgap between
touch panel and finger.
After modification, confirm new sensitivity selection by pushing
ENTER button. To rescind sensitivity selection, push BACK button.