10
Need help?
www.WilsonElectronics.com
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
Safety Guidelines
WARNING:
To uphold compliance with network protection standards, all active cellular devices must maintain
at least 6 feet of separation distance from Panel and Dome antennas.
WARNING:
Connecting the Signal Booster directly to the cell phone with use of an adapter will damage the cell
phone.
WARNING:
Use only the power supply provided in this package. Use of a non-Wilson Electronics product may
damage your equipment.
WARNING:
The Signal Booster unit is designed for use in an indoor, temperature-controlled environment (less
than 150 degrees Fahrenheit). It is not intended for use in attics or similar locations subject to
temperatures in excess of that range.
WARNING:
Warning: The Outside Antenna must be installed no higher than 10 meters (31’9”) above ground.
WARNING:
Take care to ensure that neither you nor the pole comes near any power lines during installation.
RF SAFETY WARNING:
Any antenna used with this device must be located at least 8 inches from all persons.
BEFORE USE
, you
MUST REGISTER THIS DEVICE
with your wireless provider
and have your provider’s consent. Most wireless providers consent to the use of
signal boosters. Some providers may not consent to the use of this device on their
network. If you are unsure, contact your provider.
You
MUST
operate this device with approved antennas and cables as specified by
the manufacturer. Antennas
MUST
be installed at least 20 cm (8 inches) from any
person.
You
MUST
cease operating this device immediately if requested by the FCC or a
licensed wireless service provider.
WARNING.
E911 location information may not be provided or may be inaccurate for
calls served by using this device.
This is a CONSUMER device.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. Changes or modifications not expressly approved by Wilson Electronics could void the authority
to operate this equipment.
