1
2
Contact Wilson’s Technical Support Department with any questions at
877-594-5766
Or email:
Hours: 7am to 6 pm MST..
Disclaimer: The information provided by Wilson Electronics, Inc. is
believed to be complete and accurate. However, no responsibility is
assumed by Wilson Electronics, Inc. for any business or personal losses
arising from its use, or for any infringements of patents or other rights of
third parties that may result from its use.
Copyright © 2010 Wilson Electronics, Inc. All rights reserved.
Warning:
Verify that both the outside antenna and the adapter extension
cable are connected to the signal booster before powering up the signal
booster.
!
For best performance, it is important
to install the antenna as high on the
truck cab as possible. The radials
should be no lower than the top of the
truck cab. We recommend that when
using a Wilson Electronics mobile
wireless signal booster, to install
the trucker antenna on the top, rear
area of the cab, the grab bar or the
headache rack.
Install the antenna at least 8 inches
away from any other antennas
to avoid interference. To avoid
impact damage, Wilson Electronics
recommends installing the antenna
on the driver’s side with a spring
between the antenna and the mount.
Impact damage is NOT covered under
warranty. Any antenna mount that has
a standard 3/8” x 24-thread female
receptacle will work with the trucker
antenna.
Secure the antenna onto the mount
by tightening with a 9/16” wrench.
CAUTION: DO NOT over tighten.
Route the cable from the trucker
antenna to the cell phone/cellular data
card adapter (sold separately) or to the
signal booster’s connector.
Extension cables up to 10 feet in
length are available. (sold separately)