WILSON AUDIO Watch Surround 2 Series, Owner'S Manual

Page: 78 / 91

W A T C H S
u r r o u n d
o
W n e r
’
S
M
A n u A l
78
W i l s o n A u d i o S p e c i a l t i e s
1. Turn off the amp.
2. Disconnect the speaker cables and remove the Surround from the wall.
3. Place the speaker on its side on a comfortable working surface.
Note: It is best to place a cloth towel under the driver so that you will not dam-
age the enclosure when unsoldering the driver.
4. Using an Allen wrench, remove the screws holding the driver in place.
5. Insert the Allen wrench into one of the driver mounting holes 1/8”. Gen-
tly lift out the driver and place it onto the foam pad covering the front
baffle.
6. Using a 1100 degree F soldering iron, heat up the solder joints and re-
move the driver.
7. Melt a small 1/8” diameter bead of solder onto the terminal posts of the
driver.
8. Slide the driver foam gasket over the wires before soldering the driver.
9. Place the replacement driver onto the cloth and solder the wires onto the
driver. The white wire connects to the positive side, and the black wire
connects to the negative. The positive side is generally indicated by a red
dot. Make sure to heat up the solder joint completely and hold firmly in
place until the solder sets.
10. Place the driver into the driver location.
11. Replace the machine screws, tightening them to 15 inch-pounds of
torque.
12. Re-install the Surround Channel on its wall-mount.
Note: Be careful not to over tighten the screws as you may damage the enclosure