Wilo 2.0-VE 22-36-52, Installation And Operating Instructions Manual

Page: 13 / 28

Transport and interim storage en
Installation and operating instructions Wilo-Helix V, FIRST V, 2.0-VE 22-36-52 13
Work on the product/unit must only be carried out when at a standstill. It is mandatory
that the procedure described in the installation and operating instructions for shutting
down the product/unit be complied with.
Immediately on conclusion of the work, all safety and protective devices must be put
back in position and/or recommissioned.
2.7 Unauthorised modification and
manufacture of spare parts
Unauthorised modification and manufacture of spare parts will impair the safety of the
product/ personnel and will make void the manufacturer’s declarations regarding safety.
Modifications to the product are only permissible after consultation with the manufac-
turer. Original spare parts and accessories authorised by the manufacturer ensure
safety. The use of other parts will absolve us of liability for consequential events.
2.8 Improper use
The operating safety of the supplied product is only guaranteed for conventional use in
accordance with Section 4 of the operating instructions. The limit values must on no
account fall under or exceed those values specified in the catalogue/data sheet.
3 Transport and interim storage
When receiving the material, check that there has been no damage during the trans-
port. If shipping damage has occurred, take all necessary steps with the carrier within
the allowed time.
CAUTION
Outside influences may cause damages. If the delivered material is to be installed
later on, store it in a dry place and protect it from impacts and any outside influences
(humidity, frost etc.).
The product should be cleaned thoroughly before it is put into temporary storage.
The product can be stored for at least one year.
Handle the pump carefully so as not to damage the unit prior to installation.
4 Application
This pump’s basic function is to pump hot or cold water, water with glycol or other low
viscosity fluids that contain no mineral oil, solid or abrasive substances, or materials
having long fibres. The manufacturer’s approval is required for use to pump corrosive
chemicals.
WARNING
Risk of explosion
Do not use this pump to handle flammable or explosive liquids.
4.1 Applications areas
ƒ
water distribution and pressure boosting
ƒ
industrial circulation systems
ƒ
process fluids
ƒ
cooling-water circuits
ƒ
firefighting and washing stations
ƒ
irrigation systems, etc.