350 VSL Operator Manual
www.wmcpumps.com
The Williamson Manufacturing Company Ltd provides no
warranty on usage of pumps. We recommend that life tests be carried out
prior to use. This information is given in good faith and believed to be
correct at the time of publishing. The Williamson Manufacturing Company
Ltd cannot accept responsibility for inaccuracy or any errors contained
herein. Copyright the Williamson Manufacturing Company Ltd 2008.
Safety, Cautions & Warnings.
When changing flow direction, allow the pump to
come to a complete stop before starting again. Failure to do
so could cause permanent damage to the motor.
Replace the fuse only with one of the same types and rating.
The fuse rating and type are stated on the rear panel.
This Pump Has Been Evaluated for Use With Water Only.
To reduce risk of electric shock, pull plug before servicing this pump.
"WARNING": This equipment must be earthed.
"WARNING": "Risk Of Electric Shock – This Pump Has Not Been Investigated For
Use In Swimming Pool Or Marine Areas."
Installation.
Before use:
·
Voltage and frequency of power supply must be the same as shown on unit
specification label.
·
The AC power must be Grounded
·
WIRING CONNECTIONS: All wiring and electrical connections must comply
with local and national electrical codes.
·
Enclosure should be either placed on a dry flat surface or mount enclosure to
wall using wall mounting hardware provided. The ambient temperature should
not exceed 40° C and adequate air flow should be provided for.
·
Tubing should be clean and routed so that bend radii are at a minimum four (4) times the tube
diameter.
·
Use a tube size of appropriate diameter for the flow rate and viscosity required.
CAUTION: Motor life will be drastically reduced if left in the stalled position for extended periods.
Williamson Manufacturing Co Ltd
Unit 5, Lady Bee Industrial Estate
Albion Street
Southwick
West Sussex BN42 4EP UK
Email: