LX4RT SERIES INSTALLATION INSTRUCTIONS
H.E. Williams, Inc. Carthage, Missouri www.hew.com 417-358-4065
Page 3
PN 49090154
TRIM SERIES (LX4RTR FLANGED TRIM VERSION)
STEP 4: INSTALL GALVANIZED FIXTURE COVER
A. For FLANGED TRIM installation, install galvanized fixture
cover supplied with fixture to protect from over spRay
during ceiling finish work.
Tape over finger holes after
installation.
1.
Align side flanges on fixture cover with end plate.
End Plate
Side Flange
Align
SIDE VIEW
2.
Overlap ends of fixture covers.
STEP 5: TAPE OVER FINGER HOLES IN FIXTURE COVERS
Tape over holes (painter’s tape)
STEP 6: FINISH CEILING TREATMENT
Including texture and paint as required.
STEP 7: INSTALL FLANGED TRIM
(AS REQUIRED FOR TRIM
APPLICATION)
A. Install and center double mitered end trim into ends of
fixture.
5.7” end trim
Side trim
1.
For row-mount application, cut the double mitered side trim,
supplied with feeder fixture, in the middle between clips that
are approximately 4” apart. Install one half of the trim into the
fixture at the start of the row and the other half of the trim
into the fixture at the end of the row. Position tight against
the double mitered end trim already installed.
Length varies by application
4” approx.
2ft max
between clips
Cut on centerline
3/4” approx.
(both ends)
DBL miter - side trim
2.
Install 8ft side trims between the previous trims installed.
Cut the last 8ft side trim to fit square with the half piece of
mitered side trim at the end.
DO NOT RECUT THE MITERED
ENDS.
Cut to length
as required
Half piece of
mitered side trim
(both ends)
8ft side trim
STEP 8: INSTALL LENSES
A. Insert one side of lens into one side of fixture housing.
B. Push the corner of the opposite side of the lens into place.
C. Continue pushing along the housing until the entire lens is
installed.
D. Cut final Row-Mount lens to length as required.
To remove lens, pry out starting with the 4 inch wide end.
Removal
C
B
A
LX4R90T CORNERS: FIXTURE LAYOUT
Corner fixture orientation follows the flow from the power
entry end to the end of the run.
LX4R90T-JR
LX4RT-4-J
POWER
ENTRY
LX4R90T-FL
FEEDER
LEFT
JOINER
RIGHT
JOINER
LEFT
JOINER
RIGHT
4FT
JOINER
LX4R90T-JR
LX4R90T-JL
SAMPLE
FIXTURE LAYOUT
VIEWED FROM ABOVE
CEILING PLANE
LX4RT
