AX2 LED SERIES
INSTALLATION INSTRUCTIONS
H.E. Williams, Inc. Carthage, Missouri www.hew.com 417-358-4065
Page 1 of 3
PN 49090150
Warning:
Caution – Risk of Shock
• This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of
the product and the hazards involved.
• LEDs are ESD (Electro Static Discharge) sensitive devices that can be easily damaged if the proper ESD mitigating steps are not taken.
• LEDs are very sensitive to mechanical damage. Caution must be taken to avoid damage to the LEDs.
• Do not use power tools to fasten the boards into the fixture. Over-torqueing the LED board fasteners will damage the boards.
• Make sure all electrical power is turned off while installing the fixture.
• This luminaire must be adequately grounded for protection against shock hazards and to assure proper operation.
• Disconnect power before servicing.
01/06/16JL
STAND-ALONE ASSEMBLY
Step 1:
T-bar mounting bracket halves are supplied as a one-piece
metal stamping. Break mounting bracket apart. Insert 1/4-
20 threaded stud into “A” half of bracket (Fig. 1).
1/4-20
Stud
Insert stud here
Bracket side “A”
Fig. 1
Step 2:
For T-bar ceiling, install mounting brackets at desired
locations. Brackets must be placed exactly on each
mounting point for correct installation and hanging of
cables.
MOUNTING INFORMATION
A
B
Nominal Unit Length Mounting Length (A) Actual Length (B)
2’
24-5/8”
25-7/8”
4’
46-13/16”
48-1/16”
8’
89-7/8”
91-1/8”
Step 3:
T-bar mounting bracket halves interlock. Snap side “B”
together with side “A” around T-bar. (Fig. 2).
T-bar ceiling grid
Insert tab
Bracket side “A”
Bracket halves lock together
with slots and tabs.
Bracket side “B”
Fig. 2
Step 4:
Suspension locations must be securely supported to the
structure before hanging light fixtures onto brackets. Use
12-gauge or stronger steel ceiling support wire (Fig. 3).
Support to structure
T-bar
1/4-20 Stud
(locked into bracket)
T-bar mounting bracket
shown fully assembled
ø5” Canopy
Thread upper cable
retainer onto stud
Suspension Cable
Hole for power feed
Fig. 3
