10
One or more source audio levels too quiet or too loud (not
mixing evenly):
1. If the RCA inputs are being used with an XLR source,
both
RCA inputs
must be used to mix evenly with the XLR source. If using a mono RCA source,
it must be wyed-out (using a Y-cable or adapter) and sent into both RCA
inputs. If just one RCA is used, when mixed with the XLR, it will not mix evenly
and will be quieter than the XLR source.
2. If the DLT microphone level is not mixing evenly with the XLR and/or RCA
sources, adjust the DLT line input level to match the microphone audio level
(see section on “DLT microphone mixing with dock sources”.
3. If the transmitted audio is distorting, turn the DLT line level down (see
section on “DLT microphone mixing with dock sources”), or turn the audio level
down at the source.
DLT/DLR not charging or indicating charge:
1. Make sure the DLT or DLR are seated firmly on the dock’s 30-pin
connector(s).
2. Check that the line cord is firmly plugged into the power supply, the power
supply is plugged into the AC outlet, and the power supply connector is
plugged in on the back of the Digi-Wave™ Dock inserted firmly until it stops.
3. Verify the dock’s green power LED is ON.
Note: DLTs do not indicate charge status when powered ON, but DLRs do.
4. On DLR, verify the NiMH batteries are installed correctly (not reversed) and
battery switch is set to “NiMH” position.
