Date: 04-September-13
Page 3 of 4
Rev: 20-March-15
Tool Required (included):
(H)
Wrench
Assembly Instruction Steps:
1. Carefully put Top (A) upside down on a carpeted or scratch-free surface.
2. Attach Leg (D) to Top (A) using Flat washer (G), spring washer (F) and Nut (E), tighten with Wrench. Repeat to
attach remaining Legs (C) to Top (A). (See
Fig.1
)
3. Check to ensure all bolts are tightened. Grip the table top and carefully turn upright. (See
Fig.2
)
4. Assembly is complete.
To install or remove the extension leaves:
1.
Un-assemble Thumb screw from bottom of slide rail, keep Thumb screw available for next step. (See
Fig.3
).
Fully open slide rails at the end of table to allow enough room to insert leaves. (See
Fig.4
). Insert
extension leaf (B&C), make sure leaf's pegs matches with the corresponding holes and board lines on table
match with the board lines on leaf, and then lift the bread and push it to close. (See
Fig.5
). Now tighten the
Thumb screw to ensure that the leaves are securely installed. (See
Fig.6
).
NOTE: Thumb screw must be
tightened for leaves to align properly with main table top.
.
2.
Repeat for the other leaf.
3.
When not in use
, the Thumb screw can be stored underneath the table on bottom of slide rail.
Fig.1
Fig.2
E x 8pcs
F x 8pcs
G x 8pcs
