17
© Wilks-USA
TX750 / TX750i
Removal Fom Storage
Before re-using, service the engine in accordance with the instructions in the following table. Table for removal
from storage only. For full service schedule, see Page 18.
Storage Time
Service Item
Within One Month
No Service Needed
One - Two Months
Drain out the original fuel from the fuel tank and refuel
Two Months - One Year
Drain out the original fuel from the fuel tank and refuel
Drain out the original fuel in the carburettor
Empty the deposit cup
Above One Year
Drain out the original fuel from the fuel tank and refuel
Drain out the original fuel in the carburettor
Empty the deposit cup
Move the engine from the storage place and start up
1. Unscrew the drain plug and drain out the fuel in the carburettor.
2. Turn off the engine switch first, disconnect the deposit cup and empty it.
Note:
Do not dump oil containers or discard engine oil into the ground. For environmental protection take discarded
engine oil in a closed container to a recycling centre.
Warning:
Fuel is extremely flammable and explosive under certain conditions. Keep cigarettes, naked flames and sparks
away from the operating site.
Service Schedule
To keep the engine in sound condition, the user should maintain it according to the table below.
Caution:
Use parts that are supplied by the manufacturer, otherwise damage to the engine may occur..
Warning:
Stop the engine before servicing. If servicing is required with the engine running, ensure there is good
ventilation in the area. Exhaust emissions contain carbon monoxide which may cause injury or be fatal if
inhaled.
Engine Oil Replacement
Place the machine on a level surface and warm up the engine for several minutes. Then stop the engine.
Remove oil filler cap. Place an oil pan under the engine. Remove the oil drain plug so that oil can be completely
drained. You will need to use a tube or other similar device to prevent oil leaking onto the frame of the pressure
washer. Check the oil drain plug, gasket oil filler cap and O-ring - if damaged replace. Reinstall the oil drain
plug. Add the oil to the upper level of the dipstick or lower threads as required.
Note: Do not dump oil containers or allow oil into the environment. Always dispose oil at an appropriate
recycling centre.
