Copyright © 2014 WILKA Schließtechnik, all rights reserved.
WILKA
can't hold liable for possible damages respectively for secondary damages of any kind occurring from direct or indirect use of this manual or the electronic cylinders.
Battery replacement
1. Place the mounting tool at the backside of the knob
and turn the knob cap counter clockwise to release
the cap. Then pull off the metal cover from the
knob.
2. Insert the battery into the knob. Please take care
that the polarity of the battery (+/-) is like printed in
the battery case.
3. Place the metal cover back on the knob and make
sure that the mark is in the right position.
4. Use the mounting tool to hold the nut and turn the
cover clockwise on the knob.
English
Important information for the battery usage
The cylinder is designed to work with one battery for a
maximum of 2 years (with less openings a day) or up to
80.000 openings (< 3
years, indoor
use, room
temperature). For outdoor usage the lifetime of the
batteries may be less especially with low temperatures.
Batteries are products whose quality and durability are
subject to enormous fluctuations. These products are not
the responsibility of WILKA Schließtechnik GmbH.
To ensure the proper functioning of the cylinder, the end-
user must ensure adequate power supply and control. In
case of decreasing battery voltage an acoustic signal is
heard during operation. It is necessary to replace the
batteries immediately.
Please use only new batteries (note the expiry date of the
batteries).
Caution: in case of total failure of the batteries the
cylinder will remain in the last technical condition (closed
or open). After closing operation the user has to insure
himself that the outer cylinder knob turns freely.
Recommended battery:
Duracell CR2
Batteries from other manufactures may have a shorter life
cycle.
Assembling the cylinder
A new cylinder will give access to all ID media presented
to it. Please prepare the cylinder’s no. with the
programming software and load the locking plan to the
cylinder before installing it into the door. (see also the
manual of the Programming Software)
Follow the instructions below for proper assembly
:
1. Insert batteries as described in the previous chapter
point 2-4.
2. Insert the cylinder through the door from outside.
3. Prepare the internal knob, remove the metal cover
and pull out the inner part.
4. Push the nut and the knob on the cylinder axis.
5. Fix the knob equally with the 6 cross screws.
6. Move the inner part carefully into the internal knob.
7. Fix the inner part with the two cross screws.
8. Insert the battery as described and move the cap
on the knob. Fasten the Cap with the mounting tool.
9. Fix the cylinder with the M5 screw
hand-
tight.
Do
not
use
electrical
screw
driver.
Afterwards
please
check
and
secure that the cam is ease-of-movement.
